|Table of Contents|

Experimental study and theoretical calculation on flexural performance of UHPC-T beams(PDF)

《建筑科学与工程学报》[ISSN:1673-2049/CN:61-1442/TU]

Issue:
2023年01期
Page:
65-74
Research Field:
建筑结构
Publishing date:

Info

Title:
Experimental study and theoretical calculation on flexural performance of UHPC-T beams
Author(s):
ZHU Qi YE Lihao CAI Wei XIE Wen
(School of Civil & Environmental Engineering and Geography Science, Ningbo University, Ningbo 315211, Zhejiang, China)
Keywords:
UHPC-T beam flexural performance cracking moment ultimate bending moment post-tensioned prestress
PACS:
TU375.1
DOI:
10.19815/j.jace.2021.08086
Abstract:
In order to study the influence of reinforcement ratio and prestress on the flexural performance of ultra-high performance concrete T-beam(UHPC-T beam), four UHPC-T beams and one ordinary concrete T-beam were designed and manufactured. The whole process characteristics of T-beam loading failure were studied by three-point bending test, and the key performance parameters such as cracking moment and ultimate bending moment of T-beam were calculated by theoretical formula. The results show that the reinforcement ratio has little effect on the cracking load of UHPC-T beam. Under the same reinforcement ratio, the ultimate bearing capacity of prestressed UHPC-T beam is about 1.4 times that of UHPC-T beam, and the ultimate bearing capacity of UHPC-T beam is about 2 times that of ordinary concrete T beam, indicating that both prestress and UHPC can significantly improve the ultimate bearing capacity of T beam. Compared with the ordinary concrete T beam, the cracks of UHPC-T beam are fine and dense, the maximum crack width develops slowly at the initial stage of loading, and the crack width and its number are significantly reduced. Compared with UHPC-T beam, prestressed UHPC-T beam can effectively inhibit the generation and development of cracks, indicating that prestress and UHPC can improve the crack resistance of T beam. The strain of normal section concrete in the mid-span of each test beam is basically proportional to the load, indicating that the plane section assumption is also applicable to prestressed UHPC-T beams and UHPC-T beams. The theoretical cracking moment and ultimate bending moment of T beam are in good agreement with the corresponding test results, and the relative error between them is less than 20%, which meets the engineering design requirements.

References:

[1] 李传习,聂 洁,潘仁胜,等.水胶比对超高性能混凝土施工与力学性能的影响[J].土木与环境工程学报(中英文),2020,42(4):164-174.
LI Chuanxi,NIE Jie,PAN Rensheng,et al.Effect of water-to-binder ratio on construction and mechanical properties of ultra-high performance concrete[J].Journal of Civil and Environmental Engineering,2020,42(4):164-174.
[2]聂 洁,李传习,钱国平,等.钢纤维形状与掺量对UHPC施工及力学特性的影响[J].材料导报,2021,35(4):04042-04052.
NIE Jie,LI Chuanxi,QIAN Guoping,et al.Effect of shape and content of steel fiber on workability and mechanical properties of ultra-high performance concrete[J].Materials Reports,2021,35(4):04042-04052.
[3]邵旭东,樊 伟,黄政宇.超高性能混凝土在结构中的应用[J].土木工程学报,2021,54(1):1-13.
SHAO Xudong,FAN Wei,HUANG Zhengyu.Application of ultra-high-performance concrete in engineering structures[J].China Civil Engineering Journal,2021,54(1):1-13.
[4]章烽锋.超高性能混凝土(UHPC)在桥梁改建工程中的应用[J].广东公路交通,2019,45(5):31-34.
ZHANG Fengfeng.Application of ultra high performance concrete(UHPC)in existing bridge reforming[J].Guangdong Highway Communications,2019,45(5):31-34.
[5]叶庆阳,薛聪聪,余 敏,等.超高性能混凝土配合比设计与抗压强度试验研究[J].工业建筑,2020,50(3):124-130,141.
YE Qingyang,XUE Congcong,YU Min,et al.Mix proportion design and compressive strength test of ultra-high performance concrete[J].Industrial Construction,2020,50(3):124-130,141.
[6]邵旭东,曹君辉.面向未来的高性能桥梁结构研发与应用[J].建筑科学与工程学报,2017,34(5):41-58.
SHAO Xudong,CAO Junhui.Research and application of high performance bridge structures toward future[J].Journal of Architecture and Civil Engineering,2017,34(5):41-58.
[7]邓宗才,王义超,肖 锐,等.高强钢筋UHPC梁抗弯性能试验研究与理论分析[J].应用基础与工程科学学报,2015,23(1):68-78.
DENG Zongcai,WANG Yichao,XIAO Rui,et al.Flexural test and theoretical analysis of UHPC beams with high strength rebars[J].Journal of Basic Science and Engineering,2015,23(1):68-78.
[8]傅元方.UHPC梁受弯性能研究[D].福州:福州大学,2016.
FU Yuanfang.Research on flexural behaviors of UHPC beams[D].Fuzhou:Fuzhou University,2016.
[9]孙小凯,刁 波,叶英华.钢筋超高性能纤维混凝土梁抗弯性能研究[J].工业建筑,2012,42(11):16-21.
SUN Xiaokai,DIAO Bo,YE Yinghua.Flexural behavior experiments of ultra-high performance concrete beams reinforced with steel bar and hybrid-fiber[J].Industrial Construction,2012,42(11):16-21.
[10]YANG I H,JOH C,KIM B S.Structural behavior of ultra high performance concrete beams subjected to bending[J].Engineering Structures,2010,32(11):3478-3487.
[11]TURKER K,HASGUL U,BIROL T,et al.Hybrid fiber use on flexural behavior of ultra high performance fiber reinforced concrete beams[J].Composite Structures,2019,229:111400.
[12]梁兴文,汪 萍,徐明雪,等.配筋超高性能混凝土梁受弯性能及承载力研究[J].工程力学,2019,36(5):110-119.
LIANG Xingwen,WANG Ping,XU Ming-xue,et al.Investigation on flexural capacity of reninforced ultra high performance concrete beams[J].Engineering Mechanics,2019,36(5):110-119.
[13]彭 飞,方 志.钢筋UHPC梁正截面抗弯承载力计算方法[J].土木工程学报,2021,54(3):86-97.
PENG Fei,FANG Zhi.Calculation approach for flexural capacity of reinforced UHPC beams[J].China Civil Engineering Journal,2021,54(3):86-97.
[14]曹 霞,常 婧,王艳俊.高强钢筋RPC梁受弯构件正截面承载力试验研究[J].河南理工大学学报(自然科学版),2015,34(1):109-115,123.
CAO Xia,CHANG Jing,WANG Yanjun.Experimental study on flexural capacity of normal section of high strength reinforced reactive powder concrete beam[J].Journal of Henan Polytechnic University(Natural Science),2015,34(1):109-115,123.
[15]林明畅.UHPC梁的抗弯性能研究[D].广州:华南理工大学,2020.
LIN Mingchang.Study on the anti-bend performance of UHPC beams[D].Guangzhou:South China University of Technology,2020.
[16]徐海宾,邓宗才.UHPC梁开裂弯矩和裂缝试验[J].哈尔滨工业大学学报,2014,46(4):87-92.
XU Haibin,DENG Zongcai.Cracking moment and crack width of ultra-high performance concrete beams[J].Journal of Harbin Institute of Technology,2014,46(4):87-92.
[17]刘 超,黄钰豪,马汝杰,等.高应变强化超高性能混凝土T形梁抗弯承载力[J].同济大学学报(自然科学版),2018,46(6):744-750.
LIU Chao,HUANG Yuhao,MA Rujie,et al.Calculation method for flexural capacity of high strain-hardening UHPC T-beams[J].Journal of Tongji University(Natural Science),2018,46(6):744-750.
[18]李立峰,范 昕,石雄伟,等.大比例预应力UHPC-T形梁抗弯性能试验研究[J].土木工程学报,2018,51(5):84-94,102.
LI Lifeng,FAN Xin,SHI Xiongwei,et al.Experimental study on flexural behavior of large-scale prestressed UHPC T-shaped beam[J].China Civil Engineering Journal,2018,51(5):84-94,102.
[19]徐海宾,邓宗才.预应力超高性能钢纤维混凝土梁受弯性能试验研究[J].建筑结构学报,2014,35(12):58-64.
XU Haibin,DENG Zongcai.Experimental research on flexural behavior of prestressed ultra-high performance steel fiber concrete beams[J].Journal of Building Structures,2014,35(12):58-64.
[20]许 浩.预应力高性能混凝土梁疲劳性能试验研究[D].石家庄:石家庄铁道大学,2015.
XU Hao.Research on fatigue property of prestressed high performance concrete beam by fatigue test[D].Shijiazhuang:Shijiazhuang Tiedao University,2015.
[21]金属材料 室温拉伸试验方法:GB/T 228—2002[S].北京:中国标准出版社,2002.
Metallic materials — tensile testing at ambient temperature:GB/T 228—2002[S].Beijing:Standards Press of China,2002.

Memo

Memo:
-
Last Update: 2023-01-01