|本期目录/Table of Contents|

[1]雷自学,晏兴威,高林.剪力钉刚度对曲线钢-混凝土箱形结合梁桥结构性能的影响[J].建筑科学与工程学报,2008,25(02):96-100.
　LEI Zi-xue,YAN Xing-wei,GAO Lin.Effect of Stiffness of Shear Studs on Structural Behavior of Curved Steel-concrete Composite Box Girder Bridges[J].Journal of Architecture and Civil Engineering,2008,25(02):96-100.
点击复制

剪力钉刚度对曲线钢-混凝土箱形结合梁桥结构性能的影响(PDF)
分享到：

《建筑科学与工程学报》[ISSN:1673-2049/CN:61-1442/TU]

卷:
25卷
期数:
2008年02期
页码:
96-100
栏目:
出版日期:
2008-06-20

文章信息/Info

Title:
Effect of Stiffness of Shear Studs on Structural Behavior of Curved Steel-concrete Composite Box Girder Bridges
作者:
雷自学1,晏兴威1,高林2
1.长安大学建筑工程学院,陕西西安710061;2.吉林省高等级公路建设局,吉林长春130021
Author(s):
LEI Zi-xue1, YAN Xing-wei1, GAO Lin2
1. School of Architectural Engineering, Chang'an University, Xi'an 710061, Shaanxi, China; 2. Jilin Provincial High Class Highway Construction Bureau, Changchun 130021, Jilin, China
关键词:
钢-混凝土箱形结合梁桥;  剪力钉;  推出试验;  滑移;  仿真分析
Keywords:
steel-concrete composite box girder bridge;  shear stud;  push-out test;  slip;  simulation analysis
分类号:
TU318
DOI:
-
文献标志码:
A
摘要:
采用有限元软件ANSYS对剪力钉推出试验进行了仿真分析,得出了与真实试验结果非常接近的荷载-滑移曲线,因而可用于实桥分析; 在SAP2000软件中用弹簧单元模拟剪力钉,其刚度采用仿真推出试验所得值,对一实桥结构进行三维空间建模分析,得出在一些荷载作用下的结构响应,以比较考虑混凝土与钢箱界面滑移与否对曲线钢-混凝土箱形结合梁桥部分结构性能的影响。结果表明:剪力钉刚度变化对于桥面板纵向应力影响较大, 但对钢箱底板纵向应力、挠度及桥梁横向位移影响较小; 曲线钢-混凝土结合梁桥剪力钉内力分布非常复杂,远非能用解析式或简化方法得出; 必须采用有限元分析法或其他严密的方法对曲线钢-混凝土结合梁桥进行研究。
Abstract:
The simulation analysis was carried out for shear stud push-out test by using ANSYS software. The load and slip curve that was quite close to that of real tests was obtained. Hence, it could be used directly in real bridges analysis. In SAP2000 software, spring elements were adopted to simulate the shear studs with shear stiffness obtained in the simulation analysis, and a 3-D model for a real bridge structure was built and analyzed. The structural responses under some loads were obtained to compare the effect of slip between the concrete deck and steel box on the structural behavior of the bridge. The results indicate that the stiffness of shear studs has relatively strong influence on the longitudinal stress of concrete deck, but has slight influence on the longitudinal stresses of the bottoms of steel box girders, defections and transverse displacement of bridges; the distribution of the internal forces of shear studs of a curved steel-concrete composite box girder bridge is very complicated, far from being calculated by analytical formulae or simplified methods. Therefore, the finite element analysis method or other rigorous methods are needed for the analysis of curved steel-concrete composite box girder bridges.

参考文献/References:

[1] 周绪红,戴 鹏,狄 谨.钢箱梁斜拉桥成桥索力优化分析[J].建筑科学与工程学报,2007,24(2):19-23. ZHOU Xu-hong,DAI Peng,DI Jin.Optimization Analysis of Cable Tensions of Dead Load State for Cable-stayed Bridge with Steel Box Girder[J].Journal of Architecture and Civil Engineering,2007,24(2):19-23.
[2]狄 谨,周绪红,游金兰,等.钢箱梁斜拉桥索塔锚固区的受力性能[J].中国公路学报,2007,20(4):48-52. DI Jin,ZHOU Xu-hong,YOU Jin-lan,et al.Mechan-ical Property of Cable-pylon Anchorage Zone of Cable-stayed Bridge with Steel Box Girder[J].China Journal of Highway and Transport,2007,20(4):48-52.
[3]华旭刚,陈政清.基于ANSYS的桥梁全模态颤振频域分析方法[J].中国公路学报,2007,20(5):41-47. HUA Xu-gang,CHEN Zheng-qing.Full-mode Flutter Frequency Domain Analysis Method of Bridge Based on ANSYS[J].China Journal of Highway and Transport,2007,20(5):41-47.
[4]VIEST I M.Investigation of Stud Shear Connectors for Composite Concrete and Steel T-beams[J].Journal of ACI,1956,27(8):875-891.
[5]SLUTTER R G,DISCOLL G C.Flexural Strength of Steel Concrete Composite Beams[J].Journal of the Structural Division,1965,91(S1):71-99.
[6]CHAPMAN J C,BALAKRISHMAN S.Experiments on Composite Beams[J].The Structural Engineering,1964,42(11):369-383.
[7]OLLGAARD J G,SLUTTER R G,FISHER J W.Shear Strength of Stud Connectors in Lightweight and Normal Weight Concrete[J].Engineering Journal of AISC,1971,8(2):55-64.
[8]ISSA M A,PATTON T A,ABDALLA H A,et al.Composite Behavior of Shear Connections in Full-depth Precast Concrete Bridge Deck Panels on Steel Stringers[J].PCI Journal,2003,48(5):76-89.
[9]胡少伟.组合梁抗扭分析与设计[M].北京:人民交通出版社,2005. HU Shao-wei.Analysis and Design of Composite Beams in Torsion[M].Beijing:China Communications Press,2005.
[10]何春林,邢静忠.ANSYS对钢筋混凝土结构弹塑性问题的仿真研究[J].煤炭工程,2007(4):80-82. HE Chun-lin,XING Jing-zhong.Simulation Research on Elastic and Plastic Issues of Reinforced Concrete with ANSYS[J].Coal Engineering,2007(4):80-82.
[11]BRONDUM-NIELSEN T.Optimum Design of Reinforced Concrete Shells and Slabs[R].Copenhagen:Technical University of Denmark,1974.
[12]TARHINI K M,FREDERICK G R.Wheel Load Distribution in I-girder Highway Bridges[J].Journal of Structural Engineering,1992,118(5):1285-1294.
[13]BROCKENBROUGH R L.Distribution Factors for Curved I-girder Bridges[J].Journal of Structural Engineering,1986,112(10):2200-2215.
[14]TABSH S W,SAHAJWANI K.Approximate Analysis of Irregular Slab-on-girder Bridges[J].Journal of Bridge Engineering,1997,2(1):11-17.

相似文献/References:

备注/Memo

备注/Memo:
收稿日期:2008-02-20
基金项目:云南省交通科技项目(TST2002204A)
作者简介:雷自学(1959-),男,陕西大荔人,副教授,E-mail:thunderleizixue@126.com。
更新日期/Last Update: 2008-06-20