|本期目录/Table of Contents|

[1]成 博,武振宇.组装式钢货架螺栓连接梁柱节点试验[J].建筑科学与工程学报,2013,30(03):71-77.
　]CHENG Bo,WU Zhen-yu.Experiment on Bolted Beam-to-column Connections in Assembled Steel Storage Racks[J].Journal of Architecture and Civil Engineering,2013,30(03):71-77.
点击复制

组装式钢货架螺栓连接梁柱节点试验(PDF)
分享到：

《建筑科学与工程学报》[ISSN:1673-2049/CN:61-1442/TU]

卷:
30卷
期数:
2013年03期
页码:
71-77
栏目:
出版日期:
2013-09-30

文章信息/Info

Title:
Experiment on Bolted Beam-to-column Connections in Assembled Steel Storage Racks
作者:
成 博，武振宇
哈尔滨工业大学 土木工程学院
Author(s):
]CHENG Bo, WU Zhen-yu
School of Civil Engineering, Harbin Institute of Technology
关键词:
钢货架; 梁柱节点; 螺栓; 刚度; 极限承载力; 耗能性能
Keywords:
steel storage rack;  beam-to-column connection;  bolt;  stiffness;  ultimate bearing capacity;  energy dissipation capacity
分类号:
-
DOI:
-
文献标志码:
A
摘要:
为了研究组装式钢货架中螺栓连接梁柱节点的刚度、承载力和耗能性能，进行了节点单调加载和反复加载试验。结果表明：改变横梁与连接板的相对位置对梁柱节点的初始刚度、极限承载力和变形特征均有影响；当横梁位于连接板上侧时，节点中承受向上拉力的一侧连接板被螺栓撕裂，此种节点的初始刚度和极限承载力最小；横梁焊接在连接板中下部的2种节点在横梁产生较大转角（超过0.18 rad）后，承载力并没有下降；在单调加载试验中，由于螺栓与螺栓孔壁之间存在着间隙，螺栓会发生滑移，使试件的弯矩转角曲线出现转折；反复加载试验得到的节点荷载转角滞回曲线呈Z形，每个加载级的节点能量耗散系数与割线刚度随着加载循环次数的增加而减小。
Abstract:
In order to investigate stiffness, bearing capacity and energy dissipation capacity of bolted beamtocolumn connections used in assembled steel storage racks, two groups of connection specimens were tested under monotonic and cyclic loading respectively. The results indicate that changing the relative position of beams and connecting plates has influence on initial stiffness, ultimate bearing capacity and deformation property of beam-to-column connections. As the beam is close to the top margin of connecting plate, the part of connecting plate bearing the upward tension is silt by the bolt. The initial stiffness and ultimate bearing capacity of this kind of connection are the lowest. As the beam is welded to the middle or lower part of the connecting plate, there is no drop for the bearing capacity of connections after the beam rotates a large angle (exceeding 0.18 rad). For squeeze of bolts, the bolt holes in column webs become larger. One side of connecting plates welded on beams shows twisted deformation. In the monotonic loading test, the gap between bolt and bolt hole makes the slippage of bolt, which makes turning points arise in the moment-rotation curves of specimens. In the cyclic loading test, the momentrotation hysteretic curves of specimens show Z-shaped. For each loading grade, the energy dissipation coefficient and scant stiffness of connections decrease with loading cycles increasing.

参考文献/References:

-

相似文献/References:

[1]吴从晓,周 云,赖伟山,等.现浇与预制装配式混凝土框架节点抗震性能试验[J].建筑科学与工程学报,2015,32(03):60.
　WU Cong-xiao,ZHOU Yun,LAI Wei-shan,et al.Experiment on Seismic Performance of Cast-in-situ andPrefabricated Concrete Frame Structure Joints[J].Journal of Architecture and Civil Engineering,2015,32(03):60.
[2]王 燕,杨 帆.对接焊缝构造形式对高强钢梁柱节点断裂性能的影响[J].建筑科学与工程学报,2018,35(04):45.
　WANG Yan,YANG Fan.Effect of Butt Weld Construction on Fracture Properties of High Strength Steel Beam-column Joints[J].Journal of Architecture and Civil Engineering,2018,35(03):45.
[3]张玉芬,周金富,朱 戈,等.高轴压比下复式钢管混凝土柱钢梁连接节点抗震性能试验[J].建筑科学与工程学报,2018,35(06):57.
　ZHANG Yu-fen,ZHOU Jin-fu,ZHU Ge,et al.Experiment on Seismic Behavior of Joint Between Composite CFST Column and Steel Beam Under High Axial Compression Ratio[J].Journal of Architecture and Civil Engineering,2018,35(03):57.
[4]李晓东,闫胤积.蜂窝式可替换塑性铰梁柱节点力学性能[J].建筑科学与工程学报,2021,38(01):90.[doi:10.19815/j.jace.2020.04017]
　LI Xiao-dong,YAN Yin-ji.Mechanical Behavior of Honeycombed Replaceable Plastic Hinged Beam-column Joints[J].Journal of Architecture and Civil Engineering,2021,38(03):90.[doi:10.19815/j.jace.2020.04017]
[5]梁书亭,杨 简,朱筱俊,等.矩形钢管混凝土柱-混凝土梁搭接式节点抗震性能研究[J].建筑科学与工程学报,2021,38(03):13.[doi:10.19815/j.jace.2019.01043]
　LIANG Shu-ting,YANG Jian,ZHU Xiao-jun,et al.Research on Seismic Performance of Lap Connection Between Rectangular CFST Column and RC Beam[J].Journal of Architecture and Civil Engineering,2021,38(03):13.[doi:10.19815/j.jace.2019.01043]
[6]靳幸福,吴晓鸣,陈安英,等.X形插板连接型钢结构梁柱节点受力性能[J].建筑科学与工程学报,2022,39(05):150.[doi:10.19815/j.jace.2022.05027]
　JIN Xing-fu,WU Xiao-ming,CHEN An-ying,et al.Mechanical Performance of Beam-column Connection Joints with X-shaped Inserted Plate in Steel Structure[J].Journal of Architecture and Civil Engineering,2022,39(03):150.[doi:10.19815/j.jace.2022.05027]
[7]郑 宏,尚永芳,苏耀烜,等.带可更换梁段的翼缘削弱型节点滞回性能研究[J].建筑科学与工程学报,2022,39(06):74.[doi:10.19815/j.jace.2021.08011]
　ZHENG Hong,SHANG Yong-fang,SU Yao-xuan,et al.Research on Hysteretic Behavior of Flange Weakened Joint with Replaceable Beam Section[J].Journal of Architecture and Civil Engineering,2022,39(03):74.[doi:10.19815/j.jace.2021.08011]
[8]丁发兴,罗开源,吕 飞,等.钢管混凝土柱-钢梁外加强环螺栓连接节点抗震性能有限元分析[J].建筑科学与工程学报,2024,41(04):10.[doi:10.19815/j.jace.2023.02095]
　DING Faxing,LUO Kaiyuan,LYU Fei,et al.Finite element analysis of seismic performance of concrete-filled steel tubular column-steel beam with external reinforcement ring bolted joint[J].Journal of Architecture and Civil Engineering,2024,41(03):10.[doi:10.19815/j.jace.2023.02095]

备注/Memo

备注/Memo:
-
更新日期/Last Update: 2014-12-18