|本期目录/Table of Contents|

[1]叶列平,宋世研.中、美规范中受压构件的正截面承载力计算[J].建筑科学与工程学报,2008,25(02):56-63.
 YE Lie-ping,SONG Shi-yan.Calculation of Design Methods for Flexure and Axial Strength of RC Columns in Chinese and American Codes[J].Journal of Architecture and Civil Engineering,2008,25(02):56-63.
点击复制

中、美规范中受压构件的正截面承载力计算(PDF)
分享到:

《建筑科学与工程学报》[ISSN:1673-2049/CN:61-1442/TU]

卷:
25卷
期数:
2008年02期
页码:
56-63
栏目:
出版日期:
2008-06-20

文章信息/Info

Title:
Calculation of Design Methods for Flexure and Axial Strength of RC Columns in Chinese and American Codes
作者:
叶列平宋世研
清华大学土木工程系,北京100084
Author(s):
YE Lie-ping, SONG Shi-yan
Department of Civil Engineering, Tsinghua University, Beijing 100084, China
关键词:
钢筋混凝土 受压构件 正截面承载力 最大和最小配筋率 配箍率 安全储备 结构抗力折减系数
Keywords:
reinforced concrete compressed member bearing capacity of normal cross section maximum and minimum reinforcement ratio stirrup reinforcement ratio safety margin structural strength reduction factor
分类号:
TU375
DOI:
-
文献标志码:
A
摘要:
对中国《混凝土结构设计规范》(GB 50010—2002)和美国ACI 318M—05规范中钢筋混凝土受压构件的最小和最大配筋率、正截面轴心受压、偏心受压承载力及其配箍构造的规定进行了对比分析。结果表明:对于轴心受压构件,美国规范中受压承载力的折减系数小于中国规范; 随着受力状态由大偏心受压向小偏心受压过渡,美国规范抗力折减系数的变化与构件的受力破坏特征有关,而中国规范的抗力折减系数基本不体现大、小偏心受压构件受力破坏特征的影响; 对于高强混凝土,中国规范在确定混凝土材料强度标准值时引入了脆性系数,而美国规范通过较高的配箍率规定来保证高强混凝土构件的受力破坏特征与普通混凝土一致。
Abstract:
A calculation and comparison of maximum and minimum reinforcement ratio, axial compression of normal cross section, eccentric compression capacity as well as transversal reinforcement configuration strength under combined flexure and axial forces, details of ties for RC columns were presented between Chinese Code for Design of Concrete Structures(GB 50010—2002)and American Code ACI 318M—05. Results show that firstly, for axial compression members, the strength reduction factor of American Code is smaller than that of Chinese Code; secondly, from the eccentric loaded column with tension failure to that with compression failure, the structural strength reduction factor of American Code changes with the failure mode, while that of Chinese Code does not; thirdly, for high-strength concrete, the brittleness factor is introduced to determine the nominal concrete material strength in Chinese Code, while a relatively larger stirrup reinforcement ratio is used in American Code to ensure that the failure mode of high-strength concrete is same to that of common concrete.

参考文献/References:

[1] 宋世研,叶列平.中、美混凝土结构设计规范正截面受弯承载力的计算对比分析[J].建筑科学,2007,23(7):28-33. SONG Shi-yan,YE Lie-ping.A Comparison of Design Methods for Flexure of RC Beams Between Chinese and American Design Codes for RC Structures[J].Building Science,2007,23(7):28-33.
[2]GB 50010-2002,混凝土结构设计规范[S]. GB 50010-2002,Code for Design of Concrete Structures[S].
[3]ACI 318M-05,Building Code Requirements for Structural Concrete and Commentary[S].
[4]陈肇元,朱金铨,吴佩刚.高强混凝土及其应用[M].北京:清华大学出版社,1992. CHEN Zhao-yuan,ZHU Jin-quan,WU Pei-gang.High Strength Concrete and Its Application[M].Beijing:Tsinghua University Press,1992.
[5]叶列平.混凝土结构[M].北京:清华大学出版社,2005. YE Lie-ping.Concrete Structures[M].Beijing:Tsinghua University Press,2005.
[6]RICHART F E.Reinforced Concrete Column Investigation Tentative Final Report of Committee 105[J].ACI Journal,1933,29(5):275-282.
[7]NILSON A H.混凝土结构设计[M].过镇海,方鄂华,庄崖屏,等,译.北京:中国建筑工业出版社,2003. NILSON A H.Design of Concrete Structures[M].Translated by GUO Zhen-hai,FANG E-hua,ZHUANG Ya-ping,et al.Beijing:China Architecture & Building Press,2003.
[8]马玉平,马 昕,崔建涛.高强度混凝土试验研究[J].建筑科学与工程学报,2005,22(3):67-69. MA Yu-ping,MA Xin,CUI Jian-tao.Experimental Research on High-strength Concrete[J].Journal of Architecture and Civil Engineering,2005,22(3):67-69.
[9]叶列平,王宇航.中、美规范钢筋混凝土梁斜截面受剪承载力的计算对比[J].建筑科学与工程学报,2008,25(1):88-95. YE Lie-ping,WANG Yu-hang.Calculation and Comparison of Shear Strength of RC Beams Between Chinese and American Codes[J].Journal of Architecture and Civil Engineering,2008,25(1):88-95.
[10]杨 璐,王元清,石永久,等.中国、欧洲钢-混凝土组合梁的设计规范比较[J].建筑科学与工程学报,2006,23(4):34-37. YANG Lu,WANG Yuan-qing,SHI Yong-jiu,et al.Design Code Comparison of Steel-concrete Composite Beam of China and Europe[J].Journal of Architecture and Civil Engineering,2006,23(4):34-37.
[11]GB 50011-2001,建筑抗震设计规范[S]. GB 50011-2001,Code for Seismic Design of Buildings[S].

相似文献/References:

[1]吴方伯,李 钧,邓利斌,等.大尺寸钢筋混凝土密肋薄腹梁抗剪性能试验[J].建筑科学与工程学报,2014,31(04):1.
 WU Fang-bo,LI Jun,DENG Li-bin,et al.Experiment on Shear Behavior of Largesize Reinforced Concrete Multiribbed Thin Web Beams[J].Journal of Architecture and Civil Engineering,2014,31(02):1.
[2]鲍文博,付亮华,陆海燕,等.钢混框剪高层结构地震能量分布及耗散研究[J].建筑科学与工程学报,2015,32(03):38.
 BAO Wen-bo,FU Liang-hua,LU Hai-yan,et al.Research on Seismic Energy Distribution and Dissipation of Reinforced Concrete Framewall Highrise Structure[J].Journal of Architecture and Civil Engineering,2015,32(02):38.
[3]延永东,姚昌建,刘荣桂,等.氯盐环境下开裂混凝土耐久性研究进展[J].建筑科学与工程学报,2015,32(04):21.
 YAN Yong-dong,YAO Chang-jian,LIU Rong-gui,et al.Research Progress on Durability of Cracked Concrete Under Chloride Environment[J].Journal of Architecture and Civil Engineering,2015,32(02):21.
[4]林 峰,黎艳翔,董 羽.CFRP加固钢筋混凝土直剪承载力试验[J].建筑科学与工程学报,2015,32(06):43.
 LIN Feng,LI Yan-xiang,DONG Yu.Experiment on Shear Transfer Capacity of Reinforced Concrete Strengthened with CFRP[J].Journal of Architecture and Civil Engineering,2015,32(02):43.
[5]吴波,乔长江.约束混凝土梁的升降温全过程轴力分析[J].建筑科学与工程学报,2010,27(01):12.
 WU Bo,QIAO Chang-jiang.Axial Force Analysis of Restrained Concrete Beams During Heating and Cooling Phases[J].Journal of Architecture and Civil Engineering,2010,27(02):12.
[6]马志林,史庆轩,王伟.钢筋混凝土联肢剪力墙弹塑性分析[J].建筑科学与工程学报,2010,27(01):60.
 MA Zhi-lin,SHI Qing-xuan,WANG Wei.Elasto-plastic Analysis of Reinforced Concrete Coupled Shear Walls[J].Journal of Architecture and Civil Engineering,2010,27(02):60.
[7]常莹莹,贡金鑫.钢筋混凝土受弯构件的延性及弯矩重分布[J].建筑科学与工程学报,2010,27(02):38.
 CHANG Ying-ying,GONG Jin-xin.Ductility and Moment Redistribution of Reinforced Concrete Flexural Members[J].Journal of Architecture and Civil Engineering,2010,27(02):38.
[8]潘元,刘伯权,邢国华,等.基于破坏准则的钢筋混凝土结构抗倒塌研究进展[J].建筑科学与工程学报,2010,27(02):51.
 PAN Yuan,LIU Bo-quan,XING Guo-hua,et al.Research Progress of Seismic Collapse Resistance of Reinforced Concrete Structures Based on Damage Criteria[J].Journal of Architecture and Civil Engineering,2010,27(02):51.
[9]屈文俊,方瑾,周国全.混凝土受弯构件受拉钢筋最小配筋率[J].建筑科学与工程学报,2011,28(01):6.
 QU Wen-jun,FANG Jin,ZHOU Guo-quan.Minimum Reinforcement Ratio of Tensile Reinforcement for Concrete Flexural Members[J].Journal of Architecture and Civil Engineering,2011,28(02):6.
[10]张云鹏,刁波,叶英华.基于Timoshenko与高阶剪切变形梁理论的RC梁极限承载力分析[J].建筑科学与工程学报,2011,28(03):67.
 ZHANG Yun-peng,DIAO Bo,YE Ying-hua.Ultimate Bearing Capacities of RC Beam Based on Timoshenko and Higher-order Shear Deformation Beam Theories[J].Journal of Architecture and Civil Engineering,2011,28(02):67.

备注/Memo

备注/Memo:
收稿日期:2008-04-05
基金项目:教育部高等学校科技创新工程重大项目培育资金项目(704003)
作者简介:叶列平(1960-),男,浙江温州人,教授,博士研究生导师,工学博士,E-mail:ylp@tsinghua.edu.cn。
更新日期/Last Update: 2008-06-20