|本期目录/Table of Contents|

[1]赵昕,张盼盼,郑毅敏,等.基于B3模型的竖向构件差异变形分析[J].建筑科学与工程学报,2010,27(01):108-116.
 ZHAO Xin,ZHANG Pan-pan,ZHENG Yi-min,et al.Differential Deformation Analysis of Vertical Member Based on B3 Model[J].Journal of Architecture and Civil Engineering,2010,27(01):108-116.
点击复制

基于B3模型的竖向构件差异变形分析(PDF)
分享到:

《建筑科学与工程学报》[ISSN:1673-2049/CN:61-1442/TU]

卷:
27卷
期数:
2010年01期
页码:
108-116
栏目:
出版日期:
2010-03-20

文章信息/Info

Title:
Differential Deformation Analysis of Vertical Member Based on B3 Model
作者:
赵昕1,张盼盼2,郑毅敏1,鄢兴祥2
1. 同济大学建筑设计研究院(集团)有限公司,上海 200092; 2.同济大学 建筑工程系,上海 200092
Author(s):
ZHAO Xin1, ZHANG Pan-pan2, ZHENG Yi-min1, YAN Xing-xiang2
1. Architectural Design & Research Institute of Tongji University(Group)Co., Ltd., Shanghai 200092, China; 2. Department of Building Engineering, Tongji University, Shanghai 200092, China
关键词:
B3模型 收缩 徐变 巨型框架伸臂核心筒结构 差异变形 变形补偿
Keywords:
B3 model shrinkage creep outrigger braced mega frame core-wall structure differential deformation deformation compensation
分类号:
TU375.4
DOI:
-
文献标志码:
A
摘要:
为研究巨型框架伸臂核心筒结构中由收缩和徐变引起的巨柱和核心筒的竖向差异变形,基于B3收缩徐变模型,采用应变增量法进行MATLAB编程,模拟荷载逐层施加的实际施工过程。对某一巨型框架伸臂核心筒结构进行了研究,考虑施工过程、混凝土收缩和徐变影响,对高层混凝土结构构件在竖向荷载作用下的竖向变形进行了计算; 计算构件在楼板施工前后巨柱和核心筒的弹性、非弹性缩短以及竖向差异变形; 进行了差异缩短变形分析,采用逐层修正法进行补偿。结果表明:考虑重力荷载、混凝土收缩和徐变时,巨柱和钢筋混凝土筒由收缩和徐变产生的非弹性变形占总变形的50%以上,且该比例随时间呈增大趋势; 巨柱和核心筒的收缩变形远小于徐变变形,收缩和徐变变形最终趋于一定值; 楼板施工结束时竖向变形近似相等的构件,在楼板施工后一定时期的竖向差异变形很大; 若顶层楼板施工结束时荷载全部施加完毕,则楼板施工后的最大竖向变形值出现在中间某一层; 对于有具体要求的特殊结构,采用逐层修正法可降低差异变形在伸臂桁架中引起的附加内力。
Abstract:
In order to study the vertical differential deformation between super columns and core-walls due to shrinkage and creep in outrigger braced mega frame core-wall structure, B3 model was applied to revealing the shrinkage and creep behavior of a tall outrigger braced mega frame core-wall structure. Through building a MATLAB program, strain incremental method was used to simulate the virtual construction process of the building by applying load sequentially story by story. The vertical deformation under gravity load was studied by taking into account the construction process, shrinkage and creep of concrete. Based on the proposed method, the compensation, the vertical deformation and the differential deformation before and subsequent to casting of floor were estimated. Differential deformation compensation was analyzed and elevation compensation for each floor was also calculated. Results show that the inelastic deformation dueto shrinkage and creep of core-walls and super-columns take up 50 percentof the total deformation. There is a tendency to increase with the developmentof shrinkage and creep. The shrinkage deformations of super-columns and core-walls are much smaller than the creep deformation, and the ultimate shrinkage and creep deformation tend to constant. The vertical deformations of members are approximately equal to the casting of floor while they are greatly different subsequent to the casting of floor. The maximum deformation subsequent to the casting of floor occurs some middle floor assuming that all loads have been applied after the top floor is casted. Compensation for each floor can significantly minimize the additional force of the outriggers caused by differential shortening for some special structures.

参考文献/References:

[1] JGJ 3—2002,高层建筑混凝土结构技术规程[S]. JGJ 3—2002,Technical Specification for Concrete Structures of High-rise Buildings[S].
[2]杨 丽,郭志恭.高层钢筋混凝土结构设计中如何考虑收缩、徐变的作用[J].工业建筑,1995,25(4):40-46. YANG Li,GUO Zhi-gong.How to Consider the Effect of Creep andShrinkage in Reinforced Concrete Tall Building Structure Design[J].Industry Building,1995,25(4):40-46.
[3]罗文斌,张保印.超高层建筑S+RC混合结构竖向变形差的工程对策[J].建筑结构学报,2000,21(6):68-73. LUO Wen-bin,ZHANG Bao-yin.Countermeasures for Different Vertical Deformation of S+RC Mixed Structures[J].Journal of Building Structures,2000,21(6):68-73.
[4]徐培福,傅学怡,王翠坤,等.复杂高层建筑结构设计[M].北京:中国建筑工业出版社,2005. XU Pei-fu,FU Xue-yi,WANG Cui-kun,et al.Design of Complex High-rise Building Structures[M].Beijing:China Architecture & BuildingPress,2005.
[5]周绪红,黄湘湘,王毅红,等.钢框架-钢筋混凝土核心筒体系竖向变形差异的计算[J].建筑结构学报,2005,26(2):66-73. ZHOU Xu-hong,HUANG Xiang-xiang,WANG Yi-hong,et al.Calculation of the Differential Shortening of Steel Frame-reinforced Concrete Core-wall Structure [J].Journal of Building Structures,2005,26(2):66-73.
[6]周绪红,黄湘湘,王毅红,等.钢框架-钢筋混凝土核心筒体系竖向变形差异补偿对结构性能的影响[J].土木工程学报,2006,39(4):15-19. ZHOU Xu-hong,HUANG Xiang-xiang,WANG Yi-hong,et al.Influence of the Vertical Deformation Compensation of Corewall Systems on the Characteristics of Steel Frame-reinforced Concrete Structures[J].China Civil Engineering Journal,2006,39(4):15-19.
[7]沈蒲生.巨型框架结构设计与施工[M].北京:机械工业出版社,2007. SHEN Pu-sheng.Design and Construction of Super Frame Structures[M].Beijing:China Machine Press,2007.
[8]RUSSELL H G,CORELY W G.Time-dependent Behavior of Columns in Water Tower Place[J].Portland Cement Association Research and Development Bulletin,1977(55):347-374.
[9]塔拉纳特 B S.高层建筑钢-混凝土-组合结构设计[M].罗福午,译.北京:中国建筑工业出版社,1992. TARANATH B S.Steel-concrete Composite Structure Design of High-rise Buildings[M].Translated by LUO Fu-wu.Beijing:China Architecture & Building Press,1992.
[10]FINTEL M,CHOSH S K,IYENGAR H.Column Shortening in Tall Structures:Prediction and Compensation[M].Skokie:Portland Cement Association,1986.
[11]PARK H S.Optimal Compensation of Differential Column Shortening in Highrise Buildings[J].The Structural Design of Tall and Special Buildings,2003,12(1):49-66.
[12]BAKER W F,KORISTA D S,NOVAK L C.Creep and Shrinkage and the Design of Super-tall Buildings-a Case Study:the Burj Dubai Tower[J].ACI Special Publications,2007(246):129-144.
[13]ACI.Prediction of Creep,Shrinkage,and Temperature Effects in Concrete Structures[M].New York:ACI,1992.
[14]CEB.CEB-FIP Model Code[M].London:Thomas Telford,1993.
[15]GARDNER N J.Comparison of Prediction Provisions for Drying Shrinkage and Creep of Normal-strength Concretes[J].Canadian Journal of Civil Engineering,2004,31(5):767-775.
[16]BAZANT Z P,BAWEJA S.Creep and Shrinkage Prediction Model for Analysis and Design of Concrete Structures:Model B3[J].Materials and Structures,1995,28(6):357-365.
[17]BAZANT Z P,KIM J.Consequences of Diffusion Theory for Shrinkage of Concrete[J].Materials and Structures,1991,24(5):323-326.
[18]王飞朝.基于有限元模型的结构动力修改程序开发[J].西安科技大学学报,2007,27(3):443-447. WANG Fei-chao.Program Development of Dynamic Modification Based on FEM Model[J].Journal of Xi'an University of Science and Technology,2007,27(3):443-447.
[19]姚继涛,刘金华,吴增良.既有结构抗力的随机过程概率模型[J].西安建筑科技大学学报:自然科学版,2008,40(4):445-449. YAO Ji-tao,LIU Jin-hua,WU Zeng-liang.Model for Stochastic Resistance of Existing Structures[J].Journal of Xi'an University of Architecture & Technology:Natural Science Edition,2008,40(4):445-449.

相似文献/References:

[1]吕志涛,潘钻峰.斜向开裂混凝土梁的瞬时及长期剪切变形[J].建筑科学与工程学报,2010,27(02):1.
 LU Zhi-tao,PAN Zuan-feng.Instantaneous and Long-term Shear Deformations of Inclined Crack Concrete Beams[J].Journal of Architecture and Civil Engineering,2010,27(01):1.
[2]潘钻峰,吕志涛.基于不确定性分析的大跨径PC箱梁桥后期备用束设计[J].建筑科学与工程学报,2010,27(03):1.
 PAN Zuan-feng,LU Zhi-tao.Design of Late Spare Tendon for Long-span PC Box Girder Bridge Based on Uncertainty Analysis[J].Journal of Architecture and Civil Engineering,2010,27(01):1.
[3]任慧韬,郭磊.减缩剂内掺对水泥砂浆材料性能的影响[J].建筑科学与工程学报,2012,29(03):55.
 REN Hui-tao,GUO Lei.Effect of Addition of Shrinkage Reducing Admixture on Properties of Cement Mortar[J].Journal of Architecture and Civil Engineering,2012,29(01):55.
[4]沈蒲生,方辉,夏心红,等.考虑施工过程和收缩徐变的框架结构简化分析[J].建筑科学与工程学报,2006,23(02):41.
 SHEN Pu-sheng,FANG Hui,XIA Xin-hong,et al.Simplified Analysis for Frame Structure Considering Construction Process, Shrinkage and Creep[J].Journal of Architecture and Civil Engineering,2006,23(01):41.
[5]王庆贺,王仕奇,谷 凡,等.考虑收缩徐变影响的两跨钢-混凝土连续组合梁长期性能预测方法[J].建筑科学与工程学报,2023,40(02):50.[doi:10.19815/j.jace.2021.10033]
 WANG Qinghe,WANG Shiqi,GU Fan,et al.Prediction procedures for long-term behavior of double-span steel-concrete continuous composite beams considering shrinkage and creep effects[J].Journal of Architecture and Civil Engineering,2023,40(01):50.[doi:10.19815/j.jace.2021.10033]

备注/Memo

备注/Memo:
收稿日期:2009-11-06
作者简介:赵 昕(1975-),男,江苏宝应人,高级工程师,工学博士,E-mail:22zx@tjadri.com。
更新日期/Last Update: 2010-03-20