«上一篇/Previous Article|本期目录/Table of Contents|下一篇/Next Article»

《建筑科学与工程学报》[ISSN:1673-2049/CN:61-1442/TU]

卷:

29卷

期数:

2012年02期

页码:

83-88

栏目:

出版日期:

2012-06-30

文章信息/Info

Title:

Analysis of Torsional Effect of Cold-formed Thin-walled Steel Residence Structure

作者:

刘向斌¹,周天华²,何鑫³,吴函恒²

1. 长安大学 基建处,陕西 西安 710064; 2. 长安大学 建筑工程学院,陕西 西安 710061; 3. 中信建筑设计研究总院有限公司,湖北 武汉 430014

Author(s):

LIU Xiang-bin¹, ZHOU Tian-hua², HE Xin³, WU Han-heng²

1. Infrastructure Projects Office, Chang'an University, Xi'an 710064, Shaanxi, China; 2. School of Civil Engineering, Chang'an University, Xi'an 710061, Shaanxi, China; 3. CITIC General Institute of Architectural Design and Research Co., Ltd, Wuhan 4300

关键词:

冷弯薄壁型钢;  住宅结构;  扭转效应;  简化计算;  有限元分析

Keywords:

cold-formed thin-walled steel;  residence structure;  torsional effect;  simplified calculation;  finite element analysis

分类号:

TU392

DOI:

-

文献标志码:

A

摘要:

为了研究冷弯薄壁型钢住宅结构平面质量中心、楼层形心与刚度中心偏差较大时,结构整体扭转效应的不利影响,将楼层平面内水平荷载(风、地震)作用下结构位移分解为平动和转动2种状态,得到相应状态下各组合墙体所承担的剪力,然后将其效应进行叠加,推导出了结构的线弹性层间扭转角及组合墙体剪力和侧移变形计算公式。对某冷弯薄壁型钢多层住宅结构在水平荷载作用下的层间扭转效应进行了简化计算,并运用ANSYS进行了数值模拟分析。结果表明:水平扭转效应对该类结构影响显著,简化计算公式和有限元程序数值模拟所得结果具有较好的一致性,简化计算公式可供实际工程中对该类结构整体扭转效应的计算分析时参考。

Abstract:

In order to study the disadvantageous influence of torsional effect of cold-formed thin-walled steel structure, whose deflections among the structural stiffness center, mass center and geometry center existed, the structural total displacements were divided into parallel displacement and rotational displacement, and the parallel shear and the rotational shear of composite walls were accordingly obtained, then the effect would be superposed. Finally, the calculation formulae of the structural linear-elasticity storey torsion angle, shear force and lateral displacement of composite walls were derived. The storey torsional effect of cold-formed thin-walled steel residence structure under horizontal load was calculated by the simplified formula, and the numerical result was analyzed by ANSYS finite element program. Results show that the calculated results using two methods are close to each other, and the structure response by torsional effect under horizontal load is distinct. The simplified formula can be used as reference on calculation of torsional effect of cold-formed thin-walled steel residence structure in engineering.

参考文献/References:

[1] JGJ 227—2011,低层冷弯薄壁型钢房屋建筑技术规程[S]. JGJ 227—2011,Technical Specification for Low-rise Cold-formed Thin-wall Steel Buildings[S].
[2]周天华,石 宇,何保康,等.冷弯型钢组合墙体抗剪承载力试验研究[J].西安建筑科技大学学报:自然科学版,2006,38(1):83-88. ZHOU Tian-hua,SHI Yu,HE Bao-kang,et al.Experimental Research on the Shear Resistance of Cold-formed Steel Stud Composed Wall[J].Journal of Xi'an University of Architecture & Technology:Natural Science Edition,2006,38(1):83-88.
[3]聂少锋,周天华,周绪红,等.冷弯型钢组合墙体抗剪承载力简化计算方法研究[J].西安建筑科技大学学报:自然科学版,2007,39(5):598-604. NIE Shao-feng,ZHOU Tian-hua,ZHOU Xu-hong,et al.Research on the Simplified Method for Calculating Shear Resistance of Cold-formed Steel Composite Wall[J].Journal of Xi'an University of Architecture & Technology:Natural Science Edition,2007,39(5):598-604.
[4]聂少锋,周天华,周绪红,等.冷弯型钢组合墙体抗侧刚度研究[J].重庆建筑大学学报,2008,30(2):75-79. NIE Shao-feng,ZHOU Tian-hua,ZHOU Xu-hong,et al.Research on Lateral Stiffness of Cold-formed Steel Composite Wall[J].Journal of Chongqing Jianzhu University,2008,30(2):75-79.
[5]沈蒲生,孟焕陵,刘 杨.考虑构件抗扭刚度的高层建筑结构抗扭计算[J].铁道科学与工程学报,2006,3(2):21-25. SHEN Pu-sheng,MENG Huan-ling,LIU Yang.Calculation of Torsion Performance of Tall Building Structures Based on Torsion Stiffness of Elements[J].Journal of Railway Science and Engineering,2006,3(2):21-25.
[6]包世华,张铜生.高层建筑结构设计与计算[M].北京:清华大学出版社,2005. BAO Shi-hua,ZHANG Tong-sheng.Design and Analysis of Tall-building Structures[M].Beijing:Tsinghua University Press,2005.
[7]GB 50009—2001,建筑结构荷载规范[S]. GB 50009—2001,Load Code for the Design of Building Structures[S].

相似文献/References:

[1]高婷婷,周绪红,刘永健,等.采用GB 50018—2002计算壁厚小于2 mm的受弯构件承载力的适用性分析[J].建筑科学与工程学报,2013,30(04):91.
　GAO Ting-ting,ZHOU Xu-hong,LIU Yong-jian,et al.Applicability Analysis of Bear Capacity of Flexural Members with Thickness Less than 2 mm Calculated Using GB 50018—2002[J].Journal of Architecture and Civil Engineering,2013,30(02):91.
[2]石 宇,王身伟,刘永健.冷弯薄壁型钢单颗自攻螺钉抗剪连接性能研究[J].建筑科学与工程学报,2014,31(02):57.
[3]石宇,周绪红,刘永健.冷弯薄壁卷边槽钢偏心受压构件承载力计算的折减强度法[J].建筑科学与工程学报,2011,28(03):40.
　SHI Yu,ZHOU Xu-hong,LIU Yong-jian.Strength-reduction Method for Load-carrying Capacity of Cold-formed Thin-walled Lipped Channel Members Under Eccentric Compression[J].Journal of Architecture and Civil Engineering,2011,28(02):40.
[4]刘向斌,周天华,聂少锋,等.冷弯薄壁型钢开口三肢拼合立柱轴压性能有限元分析[J].建筑科学与工程学报,2011,28(03):119.
　LIU Xiang-bin,ZHOU Tian-hua,NIE Shao-feng,et al.Finite Element Analysis of Cold-formed Thin-walled Steel Three Open Limbs Built-up Columns Under Axial Compression[J].Journal of Architecture and Civil Engineering,2011,28(02):119.
[5]聂少锋,周天华,熊智刚,等.冷弯薄壁型钢开洞组合墙体抗剪性能研究[J].建筑科学与工程学报,2012,29(01):101.
　NIE Shao-feng,ZHOU Tian-hua,XIONG Zhi-gang,et al.Research on Shear Resistance Behavior of Cold-formed Thin-walled Steel Composite Walls with Opening[J].Journal of Architecture and Civil Engineering,2012,29(02):101.
[6]周绪红,李喆,刘永健,等.冷弯薄壁型钢拼合截面柱轴压承载力计算[J].建筑科学与工程学报,2012,29(04):1.
　ZHOU Xu-hong,LI Zhe,LIU Yong-jian,et al.Calculation Method for Bearing Capacity of Cold-formed Steel Built-up Columns Under Axial Compression[J].Journal of Architecture and Civil Engineering,2012,29(02):1.
[7]刘晶波,陈鸣,刘祥庆,等.低层冷弯薄壁型钢结构住宅整体性能分析[J].建筑科学与工程学报,2008,25(04):6.
　LIU Jing-bo,CHEN Ming,LIU Xiang-qing,et al.Integral Behavior Analysis of Cold-formed Thin-walled Steel Framing System of Low-rise Residential Buildings[J].Journal of Architecture and Civil Engineering,2008,25(02):6.
[8]周绪红,李艳敏,石宇,等.竖向荷载作用下冷弯薄壁型钢墙架柱的承载力[J].建筑科学与工程学报,2006,23(03):7.
　ZHOU Xu-hong,LI Yan-min,SHI Yu,et al.Bearing Capacity of Cold-Formed Thin-WalledSteel Wall Stud Under Vertical Load[J].Journal of Architecture and Civil Engineering,2006,23(02):7.
[9]管 宇,周绪红,石 宇,等.多层冷弯薄壁型钢住宅体系动力时程分析[J].建筑科学与工程学报,2018,35(05):142.
　GUAN Yu,ZHOU Xu-hong,SHI Yu,et al.Dynamic Time History Analysis for Mid-rise Cold-formed Thin-walled Steel Residential Building System[J].Journal of Architecture and Civil Engineering,2018,35(02):142.
[10]姚欣梅,周绪红,张 辉,等.冷弯薄壁型钢C形梁受剪性能分析[J].建筑科学与工程学报,2018,35(05):152.
　YAO Xin-mei,ZHOU Xu-hong,ZHANG Hui,et al.Shear Behavior Analysis of Cold-formed Thin-walled Steel C-shape Beam[J].Journal of Architecture and Civil Engineering,2018,35(02):152.

备注/Memo

备注/Memo:

收稿日期:2012-01-16
基金项目:中央高校基本科研业务费专项资金项目(CHD2012TD012)
作者简介:刘向斌(1983-),男,陕西凤翔人,工学硕士,E-mail:lbx_818@163.com。

常用功能

更新日期/Last Update: 2012-06-20