|本期目录/Table of Contents|

[1]管 宇,周绪红,石 宇,等.多层冷弯薄壁型钢住宅体系动力时程分析[J].建筑科学与工程学报,2018,35(05):142-151.
　GUAN Yu,ZHOU Xu-hong,SHI Yu,et al.Dynamic Time History Analysis for Mid-rise Cold-formed Thin-walled Steel Residential Building System[J].Journal of Architecture and Civil Engineering,2018,35(05):142-151.
点击复制

多层冷弯薄壁型钢住宅体系动力时程分析(PDF)
分享到：

《建筑科学与工程学报》[ISSN:1673-2049/CN:61-1442/TU]

卷:
35卷
期数:
2018年05期
页码:
142-151
栏目:
出版日期:
2018-09-03

文章信息/Info

Title:
Dynamic Time History Analysis for Mid-rise Cold-formed Thin-walled Steel Residential Building System
作者:
 管 宇，周绪红，石 宇，姚欣梅
长安大学建筑工程学院
Author(s):
GUAN Yu, ZHOU Xu-hong, SHI Yu, YAO Xin-mei
School of Civil Engineering, Chang‘an University
关键词:
冷弯薄壁型钢; 多层住宅; 抗震性能; 动力时程分析; 数值模拟
Keywords:
cold-formed thin-walled steel;  mid-rise residential building;  seismic performance;  dynamic time history analysis;  numerical simulation
分类号:
-
DOI:
-
文献标志码:
A
摘要:
在采用有限元方法验证三层冷弯薄壁型钢房屋振动台试验结果的基础上，建立了多层冷弯薄壁型钢结构住宅空间整体模型，分析了模型前3阶自振频率、振型以及双向地震作用下的加速度、位移响应和水平地震剪力，考察了多层房屋的抗震性能。结果表明：《低层冷弯薄壁型钢房屋建筑技术规程》推荐的基频计算方法适用于多层冷弯薄壁型钢结构体系；随着输入地震波峰值加速度的增加，模型各层加速度幅值、相对位移和最大剪重比均增大，而各层峰值加速度放大系数有降低的趋势；随着结构高度的增加，模型各层峰值加速度放大系数、相对位移和最大剪重比均增大；多层冷弯薄壁型钢结构体系在多遇地震和罕遇地震作用下结构X向和Y向的水平地震剪力和最大层间位移角满足《建筑抗震设计规范》的要求，具备较好的抗震性能。
Abstract:
The spatial models of mid-rise cold-formed thin-walled steel residential building were established based on the shaking table test results of three-storey cold-formed thin-walled steel building verified by finite element method. In order to investigate seismic performance of midrise building, the first three natural frequencies and vibration modes as well as acceleration response, displacement response and horizontal seismic shear under bidirectional earthquake action were conducted on spatial finite element models. The results show that the fundamental frequency calculation method recommended in Technical Specification for Low-rise Cold-formed Thin-walled Steel Buildings is appropriate for mid-rise cold-formed thinwalled steel structural system. The acceleration amplitude, relative displacement and maximum shear-weight ratio of each floor raise with the increase of seismic-wave acceleration amplitude, while the peak acceleration amplification coefficient of each floor decreases. Moreover, the peak acceleration amplification coefficient, relative displacement and maximum shear weight ratio of each floor raise with the increase of structural height. The horizontal seismic shear force and maximum story-drift ratio of mid-rise cold-formed thin-walled steel structural system in X and Y direction under frequently earthquake and rare earthquake are satisfied with the requirement of Code for Seismic Design of Buildingswhich demonstrating that this structural system [JP2]has better seismic behavior.

参考文献/References:

相似文献/References:

[1]高婷婷,周绪红,刘永健,等.采用GB 50018—2002计算壁厚小于2 mm的受弯构件承载力的适用性分析[J].建筑科学与工程学报,2013,30(04):91.
　GAO Ting-ting,ZHOU Xu-hong,LIU Yong-jian,et al.Applicability Analysis of Bear Capacity of Flexural Members with Thickness Less than 2 mm Calculated Using GB 50018—2002[J].Journal of Architecture and Civil Engineering,2013,30(05):91.
[2]石 宇,王身伟,刘永健.冷弯薄壁型钢单颗自攻螺钉抗剪连接性能研究[J].建筑科学与工程学报,2014,31(02):57.
[3]石宇,周绪红,刘永健.冷弯薄壁卷边槽钢偏心受压构件承载力计算的折减强度法[J].建筑科学与工程学报,2011,28(03):40.
　SHI Yu,ZHOU Xu-hong,LIU Yong-jian.Strength-reduction Method for Load-carrying Capacity of Cold-formed Thin-walled Lipped Channel Members Under Eccentric Compression[J].Journal of Architecture and Civil Engineering,2011,28(05):40.
[4]刘向斌,周天华,聂少锋,等.冷弯薄壁型钢开口三肢拼合立柱轴压性能有限元分析[J].建筑科学与工程学报,2011,28(03):119.
　LIU Xiang-bin,ZHOU Tian-hua,NIE Shao-feng,et al.Finite Element Analysis of Cold-formed Thin-walled Steel Three Open Limbs Built-up Columns Under Axial Compression[J].Journal of Architecture and Civil Engineering,2011,28(05):119.
[5]聂少锋,周天华,熊智刚,等.冷弯薄壁型钢开洞组合墙体抗剪性能研究[J].建筑科学与工程学报,2012,29(01):101.
　NIE Shao-feng,ZHOU Tian-hua,XIONG Zhi-gang,et al.Research on Shear Resistance Behavior of Cold-formed Thin-walled Steel Composite Walls with Opening[J].Journal of Architecture and Civil Engineering,2012,29(05):101.
[6]刘向斌,周天华,何鑫,等.冷弯薄壁型钢住宅结构整体扭转效应分析[J].建筑科学与工程学报,2012,29(02):83.
　LIU Xiang-bin,ZHOU Tian-hua,HE Xin,et al.Analysis of Torsional Effect of Cold-formed Thin-walled Steel Residence Structure[J].Journal of Architecture and Civil Engineering,2012,29(05):83.
[7]周绪红,李喆,刘永健,等.冷弯薄壁型钢拼合截面柱轴压承载力计算[J].建筑科学与工程学报,2012,29(04):1.
　ZHOU Xu-hong,LI Zhe,LIU Yong-jian,et al.Calculation Method for Bearing Capacity of Cold-formed Steel Built-up Columns Under Axial Compression[J].Journal of Architecture and Civil Engineering,2012,29(05):1.
[8]刘晶波,陈鸣,刘祥庆,等.低层冷弯薄壁型钢结构住宅整体性能分析[J].建筑科学与工程学报,2008,25(04):6.
　LIU Jing-bo,CHEN Ming,LIU Xiang-qing,et al.Integral Behavior Analysis of Cold-formed Thin-walled Steel Framing System of Low-rise Residential Buildings[J].Journal of Architecture and Civil Engineering,2008,25(05):6.
[9]周绪红,李艳敏,石宇,等.竖向荷载作用下冷弯薄壁型钢墙架柱的承载力[J].建筑科学与工程学报,2006,23(03):7.
　ZHOU Xu-hong,LI Yan-min,SHI Yu,et al.Bearing Capacity of Cold-Formed Thin-WalledSteel Wall Stud Under Vertical Load[J].Journal of Architecture and Civil Engineering,2006,23(05):7.
[10]姚欣梅,周绪红,张 辉,等.冷弯薄壁型钢C形梁受剪性能分析[J].建筑科学与工程学报,2018,35(05):152.
　YAO Xin-mei,ZHOU Xu-hong,ZHANG Hui,et al.Shear Behavior Analysis of Cold-formed Thin-walled Steel C-shape Beam[J].Journal of Architecture and Civil Engineering,2018,35(05):152.

备注/Memo

备注/Memo:
更新日期/Last Update: 2018-09-03